DTC U3000-51: CAN Gateway Programming Error (CAN Gateway)

NOTE: 

• Before you troubleshoot, review the general troubleshooting information - Refer to: How to Troubleshoot the Fuel and Emissions Systems (2014-15) or How to Troubleshoot the Fuel and Emissions Systems (2017) .
• This DTC is indicated when the CAN gateway update is not completed.

DTC (CAN GATEWAY)

1. Problem verification

   -1. Turn the vehicle to the ON mode.

   - 2. Clear the DTC with the HDS.

   - 3. Turn the vehicle to the OFF (LOCK) mode.

   - 4. Turn the vehicle to the ON mode.

   - 5. Check for DTCs with the HDS.

   DTC Description	DTC
   U3000-51 CAN Gateway Programming Error

   Is DTC U3000-51 indicated?

   YES 

   Reprogram the CAN gateway .

   NO 

   Intermittent failure, the system is OK at this time. If the on-board snapshot of this DTC is recorded, try to reproduce the failure under the same conditions with the on-board snapshot - Refer to: How to Troubleshoot the Fuel and Emissions Systems (2014-15) or How to Troubleshoot the Fuel and Emissions Systems (2017) .