DTC B1226 or DTC indicator B and AUTO: A Short in the In-Car Temperature Sensor Circuit
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Do the self-diagnostic function with the HDS (see HOW TO USE THE SELF-DIAGNOSTIC FUNCTION WITH THE HDS ) or the climate control unit (see HOW TO USE THE SELF-DIAGNOSTIC FUNCTION WITHOUT THE HDS ).
- Check for DTCs.
Is DTC B1226 or B and AUTO indicated?
YES -Go to step 5.
NO -Intermittent failure, check for loose wires or poor connections in the in-car temperature sensor circuit.
- Turn the ignition switch to LOCK (0).
- Remove the humidity/in-car temperature sensor (see HUMIDITY/IN-CAR TEMPERATURE SENSOR REPLACEMENT ),
and test it (see HUMIDITY/IN-CAR TEMPERATURE SENSOR TEST ).
Is the in-car temperature sensor OK?
YES -With the in-car temperature sensor disconnected, go to step 7.
NO -Replace the humidity/in-car temperature sensor (see HUMIDITY/IN-CAR TEMPERATURE SENSOR REPLACEMENT ).
- Disconnect the climate control unit 36P connector.
- Check for continuity between climate control unit 36P connector terminal No. 20 and body ground.Fig 1: Checking Continuity Between Climate Control Unit 36P Connector Terminal No. 20 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair a short to body ground in the wire between the climate control unit and the in-car temperature sensor.
NO -Go to step 9.
- Check for continuity between climate control unit 36P connector terminals No. 1 and No. 20.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair a short in the wires between the climate control unit and the in-car temperature sensor.
NO -Substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit (see CLIMATE CONTROL UNIT REMOVAL/INSTALLATION ).