LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> Insight LX >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Climate Control >> DTC Troubleshooting >> DTC B1225 or DTC indicator A and AUTO: An Open in the In-Car Temperature Sensor Circuit

DTC B1225 or DTC indicator A and AUTO: An Open in the In-Car Temperature Sensor Circuit

  1. Clear the DTCs with the HDS.
  2. Turn the ignition switch to LOCK (0) and then back to ON (II).
  3. Do the self-diagnostic function with the HDS (see HOW TO USE THE SELF-DIAGNOSTIC FUNCTION WITH THE HDS ) or the climate control unit (see HOW TO USE THE SELF-DIAGNOSTIC FUNCTION WITHOUT THE HDS ).
  4. Check for DTCs.

    Is DTC B1225 or A and AUTO indicated? 

    YES  -Go to step 5.

    NO  -Intermittent failure, check for loose wires or poor connections in the in-car temperature sensor circuit.

  5. Turn the ignition switch to LOCK (0).
  6. Remove the humidity/in-car temperature sensor (see HUMIDITY/IN-CAR TEMPERATURE SENSOR REPLACEMENT ), and test it (see HUMIDITY/IN-CAR TEMPERATURE SENSOR TEST ).

    Is the in-car temperature sensor OK? 

    YES  -With the in-car temperature sensor disconnected, go to step 7.

    NO  -Replace the humidity/in-car temperature sensor (see HUMIDITY/IN-CAR TEMPERATURE SENSOR REPLACEMENT ).

  7. Disconnect the climate control unit 36P connector.
  8. Check for continuity between climate control unit 36P connector terminal No. 20 and humidity/in-car temperature sensor 4P connector terminal No. 1.
    Fig 1: Checking Continuity Between Climate Control Unit 36P Connector Terminal No. 20 And Humidity/In-Car Temperature Sensor 4P Connector Terminal No. 1
    G08094297Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Go to step 9.

    NO  -Repair an open in the wire between the climate control unit and the in-car temperature sensor.

  9. Check for continuity between climate control unit 36P connector terminal No. 1 and humidity/in-car temperature sensor 4P connector terminal No. 2.
    Fig 2: Checking Continuity Between Climate Control Unit 36P Connector Terminal No. 1 And Humidity/In-Car Temperature Sensor 4P Connector Terminal No. 2
    G08094298Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Check for loose wires or poor connections at the climate control unit 36P connector and at the humidity/in-car temperature sensor 4P connector. If the connections are good, substitute a known-good climate control unit, and recheck. If the symptom/indication goes away, replace the original climate control unit (see CLIMATE CONTROL UNIT REMOVAL/INSTALLATION ).

    NO  -Repair an open in the wire between the climate control unit and the in-car temperature sensor.