Glove Box Striker Replacement

SRS components are located in this area. Review the SRS component locations (see COMPONENT LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES ) before doing repairs or service.

1. While holding the glove box (A), release the glove box stops (B) on each side from the dashboard by pushing them in, then lower the glove box.
   Fig 1: Releasing Glove Box Stops On Side From Dashboard

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the screws, then remove the glove box striker (A).
   Fig 2: Identifying Glove Box Striker And Screws

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install the glove box striker in the reverse order of removal.