Entering the self-diagnostic function (manual method)
- Push and hold the SEL/RESET button.
- Turn the combination light switch ON.
- Turn the ignition switch to ON (II).
- Within 2 - 5 sec, turn the combination light switch OFF, then ON and OFF again.
- Within 5 sec, release the SEL/RESET button, and then push and release the button three times repeatedly.
NOTE:
- While in the self-diagnostic mode, the dashlights brightness controller operates normally.
- While in the self-diagnostic mode, the SEL/RESET switch is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
- If the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned to LOCK (0), the self-diagnostic mode ends.
Courtesy of AMERICAN HONDA MOTOR CO., INC.