DTC 31-11: ABS Solenoid Valve Malfunction; DTC 32-11: ABS Solenoid Valve Malfunction; DTC 33-11: ABS Solenoid Valve Malfunction; DTC 34-11: ABS Solenoid Valve Malfunction; DTC 35-11: ABS Solenoid Valve Malfunction; DTC 36-11: ABS Solenoid Valve Malfunction; DTC 37-11: ABS Solenoid Valve Malfunction; DTC 38-11: ABS Solenoid Valve Malfunction
NOTE:
Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION
).
- Turn the ignition switch to ON (II).
- Clear the DTC with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Check for DTCs with the HDS.
Is DTC 31-11, 32-11, 33-11, 34-11, 35-11, 36-11, 37-11, or 38-11 indicated?
YES -Go to step 5.
NO -Intermittent failure, the system is OK at this time. Refer to INTERMITTENT FAILURES TROUBLESHOOTING
- Update the VSA modulator-control unit if it does not have the latest software (see VSA MODULATOR-CONTROL UNIT UPDATE ).
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Check for DTCs with the HDS.
Is DTC 31-11, 32-11, 33-11, 34-11, 35-11, 36-11, 37-11, or 38-11 indicated?
YES -Check for loose terminals in the VSA modulator-control unit 36P connector. If the VSA modulator-control unit was updated and the symptom/indication is still present, replace the VSA modulator-control unit (see VSA MODULATOR-CONTROL UNIT REMOVAL AND INSTALLATION ).
NO -If the VSA modulator-control unit was updated, troubleshooting is complete. If any other DTCs are indicated, go to the indicated DTCS TROUBLESHOOTING .