Input Shaft Oil Seal Replacement

Special Tools Required 

• Driver Handle, 15 x 135L 07749-0010000
• Bearing Driver Attachment, 37 x 40 mm 07746-0010200

1. Remove the input shaft oil seal from the flywheel housing.
   Fig 1: Removing Input Shaft Oil Seal From Flywheel Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new input shaft oil seal (A) to a depth of 2.5-3.5 mm (0.098-0.138 in) (B) below the flywheel housing level (C) using the 15 x 135L driver handle and the 37 x 40 mm bearing driver attachment.
   Fig 2: Installing Input Shaft Oil Seal To Depth Of 2.5-3.5 mm (0.098-0.138 in) Below Flywheel Housing Level

   Courtesy of AMERICAN HONDA MOTOR CO., INC.