CVTF Feed Pipe/Feed Pipe Guide Replacement

Remove the snap ring (A) from the flywheel housing on the CVTF feed pipe/feed pipe guide (B), then remove the CVTF feed pipe/feed pipe guide.

Fig 1: Locating Snap Ring And CVTF Feed Pipe/Feed Pipe Guide
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the feed pipe guide (A) from the CVTF feed pipe (B), and remove the O-rings (C) from the feed pipe guide.

Fig 2: Locating Feed Pipe Guide, CVTF Feed Pipe And O-Rings
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Replace the CVTF feed pipe or the feed pipe guide, then install new O-rings to the feed pipe guide.
Install the CVTF feed pipe through the feed pipe guide.
Install the CVTF feed pipe/feed pipe guide (A) to the flywheel housing by aligning the CVTF feed pipe tabs (B) with the guides (C) on the flywheel housing.

Fig 3: Locating CVTF Feed Pipe/Feed Pipe Guide, CVTF Feed Pipe Tabs And Guides
Courtesy of AMERICAN HONDA MOTOR CO., INC.
After installing the CVTF feed pipe/feed pipe guide, install and check that the snap ring is seated in the feed pipe guide and the housing groove, and that the ring end gap (A) is 5.4 mm (0.213 in) or more.

Fig 4: Identifying Ring End Gap
Courtesy of AMERICAN HONDA MOTOR CO., INC.