LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Suspension >> Wheels & Tire System >> Tire Pressure Monitoring System >> DTC Troubleshooting >> DTC 83: No VSP Signal

DTC 83: No VSP Signal

NOTE: If DTC 85 stored at the same time as DTC 83, troubleshoot DTC 85 first, then recheck for DTC 83.
  1. Turn the ignition switch to ON (II).
  2. Clear the DTC with the HDS.
  3. Test-drive the vehicle at 7 mph (10 km/h) or more.
  4. Check the speedometer.

    Does the speedometer register speed? 

    YES  -Go to step  5.

    NO  -Update the ECM/PCM if it does not have the latest software (see ELD REPLACEMENT ), or substitute a known-good ECM/PCM (see SUBSTITUTING THE ECM/PCM ), then go to step  1 and recheck. If the ECM/PCM was updated and DTCs are not indicated, troubleshooting is complete. If the ECM/PCM was substituted and DTCs are not indicated, replace the original ECM/PCM (see ECM/PCM REPLACEMENT ).

  5. Check the VEHICLE SPEED in the TPMS DATA LIST with the HDS.

    Is the vehicle speed indicated? 

    YES  -Intermittent failure, the system is OK at this time.

    NO  -Substitute a known-good TPMS control unit (see TPMS CONTROL UNIT REPLACEMENT  ), and recheck.

scientia non olet · About LEMON Manuals