Side Impact Sensor (Second) Replacement: Installation
- Install the side impact sensor (second) (A) with a new TORX bolt (B), using a TORX T30 bit. Connect the side impact sensor (second) 2P connector (C).
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- Do the 12 volt battery terminal reconnection procedure (see
12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION
).
- Clear any DTCs with the HDS (see HOW TO CLEAR DTCS
).
- Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds, and then goes off.
- Reinstall all removed parts.