Wiring Precautions

Some of the SRS wiring can be identified by a special yellow outer covering and the SRS connectors can be identified by their yellow color. Observe the following instructions.

• Never attempt to modify, splice, or repair SRS wiring. If there is an open or damage to the SRS wiring, replace the harness.
  Fig 1: Precaution - Never Attempt To Modify, Splice, Or Repair SRS Wiring

  Courtesy of AMERICAN HONDA MOTOR CO., INC.
• Be sure to install the harness wires so they do not get pinched or interfere with other parts.
  Fig 2: Precaution - Be Sure To Install Harness Wires So They Do Not Get Pinched Or Interfere With Other Parts

  Courtesy of AMERICAN HONDA MOTOR CO., INC.
• Make sure all SRS ground locations are clean, and the grounds are securely fastened for optimum metal-to-metal contact. Poor grounds can cause intermittent problems that are difficult to diagnose.
• Do not use any silicone based cleaners or lubricants on any SRS connectors or terminals.