Precautions for Electrical Inspections

Special Tools Required 

Back Probe Adapter, 17 mm 07TAZ-001020A

• Make sure the 12 volt battery is fully charged when doing electrical test. If the 12 volt battery is not fully charged, the results of the tests may not be accurate.
• When using electrical test equipment, insert the probe of the tester into the wire side of the connector (except water proof connector). Do not insert the probe of the tester into the terminal side of the connector, and do not tamper with the connector.
  Fig 1: Precaution - Do Not Insert Probe Of Tester Into Terminal Side Of Connector

  Courtesy of AMERICAN HONDA MOTOR CO., INC.
• Use the back probe adapter, 17 mm (07TAZ-001020A). Do not insert the probe forcibly.
  Fig 2: Precaution - Use Back Probe Adapter, 17 mm

  Courtesy of AMERICAN HONDA MOTOR CO., INC.
• Use specified service connectors in troubleshooting.

  Using improper tools could cause a diagnostic error due to poor metal-to-metal contact.