LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver's Seat Position Sensor Replacement >> Removal

Driver's Seat Position Sensor Replacement: Removal

NOTE: Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.
  1. Do the 12 volt battery terminal disconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ), then wait at least 3 minutes before starting work.
  2. Raise the driver's seat all the way up.
  3. Remove the outer recline cover (see RECLINE COVER REMOVAL/INSTALLATION ).
  4. Detach the clip (A), then disconnect the seat position sensor sub harness 2P connector (B) from the driver's seat position sensor (C).
    Fig 1: Identifying Clip, Seat Position Sensor Sub Harness 2P Connector, Driver's Seat Position Sensor And TORX Bolt
    G06952565Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Remove the TORX bolt (D) using a TORX T30 bit, then remove the driver's seat position sensor.
scientia non olet · About LEMON Manuals