LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> Driver's Seat Position Sensor Replacement >> Installation

Driver's Seat Position Sensor Replacement: Installation

NOTE:
  • Be sure to install the harness so it does not pinch or interfere with other parts.
  • Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.
  1. Install the driver's seat position sensor (A) with a new TORX bolt (B).
    Fig 1: Driver's Seat Position Sensor, TORX Bolt, 2P Connector And Clip With Torque Specifications
    G06952566Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Connect the driver's seat position sensor 2P connector (C), then install the clip (D).
  3. Install the outer recline cover (see RECLINE COVER REMOVAL/INSTALLATION ).
  4. Do the 12 volt battery terminal reconnection procedure (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
  5. Clear any DTCs with the HDS (see HOW TO CLEAR DTCS  ).
  6. Check the operation of the driver's seat position sensor with the HDS (see DRIVER'S SEAT POSITION SENSOR OPERATION CHECK  ).
  7. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
scientia non olet · About LEMON Manuals