DTC Fx-11 ("x" can be 0 thru 9 or A thru F): Airbags And/or Tensioners Deployment Recorded
NOTE:
- Before doing this troubleshooting procedure, find out if the vehicle was in a collision. If so, verify that all the required components were replaced with new components, of the correct part number, and that they were properly installed (see COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT ).
- Before doing this troubleshooting procedure, review SRS Precautions and Procedures (see PRECAUTIONS AND PROCEDURES ), General Troubleshooting Information (see DTC (DIAGNOSTIC TROUBLE CODES) ), and 12 Volt Battery Terminal Disconnection and Reconnection (see 12 VOLT BATTERY TERMINAL DISCONNECTION AND RECONNECTION ).
- Refer to the DTCs shown:
- DTC F1-11 DRIVER'S AIRBAG AND/OR DRIVER'S SEAT BELT TENSIONER DEPLOYED .
- DTC F2-11 FRONT PASSENGER'S AIRBAG AND/OR FRONT PASSENGER'S SEAT BELT TENSIONER DEPLOYED .
- DTC F3-11 DRIVER'S SIDE AIRBAG, LEFT SIDE CURTAIN AIRBAG AND/OR DRIVER'S SEAT BELT TENSIONER DEPLOYED .
- DTC F4-11 FRONT PASSENGER'S SIDE AIRBAG, RIGHT SIDE CURTAIN AIRBAG AND/OR FRONT PASSENGER'S SEAT BELT TENSIONER DEPLOYED .
- DTC F5-11 BOTH OR ONLY ONE SIDE CURTAIN AIRBAG AND SEAT BELT TENSIONER DEPLOYED .
- DTC F6-11 LEFT SIDE CURTAIN AIRBAG OR RIGHT SIDE CURTAIN AIRBAG DEPLOYED .
When any airbag or tensioners have deployed, go to COMPONENT REPLACEMENT/INSPECTION AFTER DEPLOYMENT .