LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> IMA System >> DTC Troubleshooting >> DTC P0BFD: Motor Current Sensor Circuit Malfunction

DTC P0BFD: Motor Current Sensor Circuit Malfunction

NOTE:
  • Before you troubleshoot, record all freeze data, and any on-board snapshot, and review the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION  ).
  • If the DTC cannot be cleared, do the troubleshooting for DTC U1204.
  1. Turn the ignition switch to ON (II).
  2. Clear the DTC with the HDS (see DTC CLEAR  ).
  3. Start the engine.
  4. Check for Pending or Confirmed DTCs with the HDS.

    Is DTC P0BFD indicated? 

    YES  -Go to step  5.

    NO  -Intermittent failure, the system is OK at this time.

  5. Check for Pending or Confirmed DTCs with the HDS.

    Is DTC P0A5E, P0A5F, P0A61, P0A62, P0A64, or P0A65 indicated? 

    YES  -Go to the INDICATED DTC'S TROUBLESHOOTING .

    NO  -Replace the phase motor current sensor (see MOTOR POWER INVERTER (MPI) MODULE REMOVAL/INSTALLATION  ), then go to step  8.

  6. Turn the ignition switch to ON (II).
  7. Clear the DTC with the HDS (see DTC CLEAR  ).
  8. Start the engine.
  9. Check for Pending or Confirmed DTCs with the HDS.

    Is DTC P0BFD indicated? 

    YES  -Go to step  1.

    NO  -Troubleshooting is complete. If any other Pending or Confirmed DTCs are indicated, go to the indicated DTC'S TROUBLESHOOTING .

scientia non olet · About LEMON Manuals