Reverse Shift Fork Clearance Inspection

WARNING: This page is about a different variant/trim than selected.

Measure the clearance between the reverse idler gear (A) and the reverse shift fork (B) with a feeler gauge (C). If the clearance exceeds the service limit, go to step 2.
Standard: 0.2-0.6 mm (0.008-0.024 in)

Service Limit: 1.2 mm (0.047 in)

Fig 1: Measuring Clearance Between Reverse Idler Gear And Reverse Shift Fork Using Feeler Gauge
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Measure the width of the reverse shift fork.
- If the width is not within the standard, replace the reverse shift fork.
- If the width is within the standard, replace the reverse idle gear.
  Standard: 14.7-14.9 mm (0.579-0.587 in)
  
  Fig 2: Identifying Selector Arm Width
  Courtesy of AMERICAN HONDA MOTOR CO., INC.