Mainshaft Disassembly

WARNING: This page is about a different variant/trim than selected.

Special Tools Required

Bearing Separator 07KAF-PS30200

NOTE: Refer to the EXPLODED VIEW in the Mainshaft Reassembly, as needed, when removing components pressed onto the mainshaft (see MAINSHAFT REASSEMBLY ).

Support 6th gear (A) on bearing separator (B), and press the mainshaft out of the angular ball bearing (C) and 6th gear.

Fig 1: Pressing Mainshaft Out Of Angular Ball Bearing And 6th Gear
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the needle bearing (A), the 6th gear distance collar (B), the synchro ring (C), the synchro spring (D), and the 5th/6th synchro sleeve (E).

Fig 2: Identifying Needle Bearing, 6th Gear Distance Collar, Synchro Ring, Synchro Spring And 5th/6th Synchro Sleeve
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 5th gear (A) on bearing separator (B), and press the mainshaft out of the 5th/6th synchro hub, synchro spring, the synchro ring, and 5th gear.

Fig 3: Pressing Mainshaft Out Of 5th/6th Synchro Hub, Synchro Spring, Synchro Ring, And 5th Gear
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Remove the needle bearings (A), the 4th/5th gear distance collar (B), the 4th gear (C), the synchro ring (D), the synchro spring (E), and the 3rd/4th synchro sleeve (F).

Fig 4: Identifying Needle Bearings, 4th/5th Gear Distance Collar, 4th Gear, Synchro Ring, Synchro Spring And 3rd/4th Synchro Sleeve
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Support 3rd gear (A) on bearing separator (B), and press the mainshaft out of the 3rd/4th synchro hub, the synchro spring, the synchro ring, 3rd gear, and the needle bearing.

Fig 5: Pressing Mainshaft Out Of 3rd/4th Synchro Hub, Synchro Spring, Synchro Ring, 3rd Gear, And Needle Bearing
Courtesy of AMERICAN HONDA MOTOR CO., INC.