LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission) >> M/T Differential >> Differential Carrier/Final Driven Gear Replacement

Differential Carrier/Final Driven Gear Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Loosen the bolts in a crisscross pattern in several steps, then remove the final driven gear (A) from the differential carrier (B).
    Fig 1: Final Driven Gear Of Differential Carrier With Torque Specifications
    G06950847Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Install the final driven gear with the chamfer on the inside diameter facing the carrier. Tighten the bolts in a crisscross pattern in several steps.
scientia non olet · About LEMON Manuals