12 Volt Battery Terminal Disconnection and Reconnection: Reconnection

NOTE: Some systems store data in memory that is lost when the battery is disconnected. Do the following procedures to restore the system back to normal operation.

Clean the battery terminals.
Test the battery (see 12 VOLT BATTERY TEST ).
Reconnect the positive cable (A) to the battery (B) first, then reconnect the negative cable (C) to the battery.
NOTE: Always connect the positive cable to the battery first.

Fig 1: Battery, Terminal Cover Positive And Negative Cable With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Apply multipurpose grease to the terminals to prevent corrosion.
Install the terminal cover (D).
Enter the anti-theft code(s) for the audio system and/or navigation system (if equipped).
Set the clock (for vehicles without navigation).