Intermediate Shaft Disassembly

Special Tools Required 

• Half Shaft Base 07NAF-SR3A101
• Oil Seal Driver, 44.5 mm 07947-SB0A100

1. Remove the outer seal (A) and the external snap ring (B) from the intermediate shaft (C).
   Fig 1: Identifying Outer Seal, Snap Ring And Intermediate Shaft

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Press the intermediate shaft (A) out of the intermediate shaft bearing (B) using a press. Be careful not to damage the bearing support ring (C) on the intermediate shaft during disassembly.
   Fig 2: Removing Intermediate Shaft From Bearing Using Press

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Remove the internal snap ring (A) from the bearing support (B).
   Fig 3: Identifying Internal Snap Ring And Bearing Support

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Press the intermediate shaft bearing (A) out of the bearing support (B) using the 44.5 mm oil seal driver (C), the half shaft base (D), and a press.
   Fig 4: Removing Intermediate Shaft Bearing From Support Using 44.5 mm Oil Seal Driver

   Courtesy of AMERICAN HONDA MOTOR CO., INC.