LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Conventional Brake Components >> Brake Pedal Pad Cover Replacement

Brake Pedal Pad Cover Replacement

NOTE:
  • This procedure shows a model equipped with a brake pedal pad cover.
  • The illustration shows an M/T model; the CVT model is similar.
  1. Cover the carpet under the brake pedal to prevent metal shavings from getting on the carpet.
  2. Center-punch each of the rivets (A), and drill their heads off with a 3 mm (0.12 in) drill bit(B).
    NOTE: Do not drill the brake pedal pad (C).
    Fig 1: Identifying Brake Pedal Pad And Rivets
    G06953169Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Remove the brake pedal plate pad cover (A) and the brake pedal cover (B) from the brake pedal pad (C).
    Fig 2: Identifying Brake Pedal Plate Pad Cover, Brake Pedal Cover And Brake Pedal Pad
    G06953170Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Set the brake pedal cover on the brake pedal plate.
  5. Install the brake pedal pad cover (A) with the rivets (B) firmly attached.
    Fig 3: Installing Brake Pedal Pad Cover With Rivets
    G06953171Courtesy of AMERICAN HONDA MOTOR CO., INC.
  6. Make sure the brake pedal cover and plate are securely fastened on the brake pedal.
  7. Check the brake pedal height (see BRAKE PEDAL AND BRAKE PEDAL POSITION SWITCH/IDLE STOP SWITCH ADJUSTMENT  ).
scientia non olet · About LEMON Manuals