Side sill panel installation

Install the side sill panel (A).
1. Install the side clips (E) on the side sill panel.
2. If necessary, install the grommet (F) to the body.
3. Hold the panel up, and fit all the side clips into the holes in the body, then push on the panel until the clips snap into place.
4. Install the clips (B) and the pin (C) of the clip (D) to the panel.
  NOTE:
  - When reinstalling the side clips, the tab (G) on the clip is facing to the upper side.
  - If the clips are damaged or stress-whitened, replace them with new ones.
  - If the grommet and pin are damaged or stress-whitened, replace the grommet and pin as an assembly with new one.
  - Push the clips and the pin into place securely.