Door Glass Adjustment

NOTE: Check the door weatherstrip and the glass run channel for damage or deterioration, and replace them if necessary.

Place the vehicle on a firm, level surface.
Remove these items:
- Door panel (see DOOR PANEL REMOVAL/INSTALLATION )
- Plastic cover (see step 5 )
Carefully lower the glass (A) until you can see the glass mounting bolts (B), then loosen them.

Fig 1: Pushing Glass Into Glass Run Channel With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Push the glass against the glass run channel (C), then tighten the glass mounting bolts.
Check that the glass moves smoothly.
Raise the glass fully, and check for gaps. Also make sure that the glass (A) contacts the glass run channel (B) evenly.

Fig 2: Identifying Glass And Glass Run Channel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Attach the plastic cover making sure it is sealed around its outside perimeter to seal out water.
Check for water leaks. Run water over the roof and on the sealing area as shown, and note these items:
- Use a 12 mm (0.47 in) diameter hose (A).
- Adjust the rate of water flow as shown (B).
- Do not use a nozzle.
- Hold the hose about 300 mm (11.81 in) away from the door (C).
  
  Fig 3: Checking For Water Leaks
  Courtesy of AMERICAN HONDA MOTOR CO., INC.
Reinstall the door panel (see DOOR PANEL REMOVAL/INSTALLATION ).
Do the power window control unit reset procedure (see RESETTING THE POWER WINDOW CONTROL UNIT ).