Security alarm system will not arm

NOTE: Before troubleshooting, check the B-CAN DTCs. If any DTC is indicated, refer to the B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A ), and troubleshoot the indicated DTC(s) first.

Turn the ignition switch to ON (II).
Select SECURITY from the BODY ELECTRICAL menu, and enter the DATA LIST with the HDS.
Check the ON/OFF information in the DATA LIST when each switch is operating.
- TRUNK LID/TAILGATE SWITCH
- SECURITY HOOD SWITCH
- DRIVER'S DOOR LOCK KNOB SWITCH (UNLOCK)
- FRONT PASSENGER'S DOOR LOCK KNOB SW (UNLOCK)
- DRIVER'S DOOR SWITCH
- FRONT PASSENGER'S DOOR SWITCH
- DRIVER'S DOOR KEY CYLINDER SWITCH (LOCK)
- DRIVER'S DOOR KEY CYLINDER SWITCH (UNLOCK)
  Is the each switch information OK?
  
  YES -Intermittent failure, the system is OK at this time.
  
  NO -Check the abnormal circuit.
  - Hatch latch switch circuit troubleshooting (see SECURITY ALARM SYSTEM WILL NOT ARM ).
  - Security hood switch circuit troubleshooting (see SECURITY HOOD SWITCH CIRCUIT TROUBLESHOOTING ).
  - Driver's door lock knob switch circuit troubleshooting (see DRIVER'S DOOR LOCK KNOB SWITCH CIRCUIT TROUBLESHOOTING ).
  - Passenger's door lock knob switch circuit troubleshooting (see PASSENGER'S DOOR LOCK KNOB SWITCH CIRCUIT TROUBLESHOOTING ).
  - Driver's door switch circuit troubleshooting (see DRIVER'S DOOR SWITCH CIRCUIT TROUBLESHOOTING ).
  - Passenger's door switch circuit troubleshooting (see PASSENGER'S DOOR SWITCH CIRCUIT TROUBLESHOOTING ).
  - Driver's door key cylinder switch circuit troubleshooting (see DRIVER'S DOOR KEY CYLINDER SWITCH CIRCUIT TROUBLESHOOTING ).