LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless/Power Door Locks/Security System >> Door Lock Knob Switch Test >> Passenger's Door

Passenger's Door

  1. Remove the passenger's door panel (see DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 10P connector (A) from the door latch (B).
    Fig 1: Identifying Door Latch And 10P Connector - Passenger's Door
    G06953917Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals.

    There should be continuity between terminals No. 7 and No. 5 when the door lock knob switch in the UNLOCK position, and no continuity when the switch is in the LOCK position.

  4. If the continuity is not specified, replace the passenger's door latch (see DOOR LATCH REPLACEMENT ).
scientia non olet · About LEMON Manuals