LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless/Power Door Locks/Security System >> Door Lock Actuator Test >> Passenger's Door

Passenger's Door

  1. Remove the passenger's door panel (see DOOR PANEL REMOVAL/INSTALLATION ).
  2. Disconnect the 10P connector (A) from the door latch (B).
    Fig 1: Identifying Door Latch And 10P Connector
    G06953914Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.
    Fig 2: Actuator Connector Terminals Operation Chart
    G06953915Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the actuator does not operate as specified, replace the passenger's door latch (see DOOR LATCH REPLACEMENT ).
scientia non olet · About LEMON Manuals