CD, DVD, and PC Card Removal/Installation

If the display will not open, use this procedure to manually open the display and remove the DVD, CD, or the PC card.

1. Remove the audio-navigation unit from the vehicle (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION  ).
2. On the bench, carefully pull the display (A) straight out (about 1/2 inch).
   Fig 1: Removing Display

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Fold down the display as shown.
   Fig 2: Folding Down Display

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Press the PC card eject button (A) to eject the customer's PC card (if installed). Power is not required for this function.
   Fig 3: Identifying PC Card Eject Button, Plastic Cover, CD Eject Button And Navigation DVD Eject Button

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
5. Open the plastic cover (B) for the navigation DVD slot. Do not remove the plastic cover.
6. With the display open, temporarily reconnect the unit in the dash (to power it up).
7. Press the CD eject button (C), and navigation DVD eject button (D) and remove the discs (hold the discs by their edges to avoid fingerprints). To avoid scratches, place the navigation DVD and the customer's CD in a jewel case if available.
8. Close the plastic cover that hides the navigation DVD slot.
9. Close the display by first returning the display to the upward position, and then pushing the entire display straight back into the unit.
10. After installing the new audio-navigation unit, re-insert the navigation DVD, the customer's CD, and the PC card.