The Bluetooth icon in the display is not displayed (without navigation)
- Turn the ignition switch to LOCK (0).
- Remove the audio unit (see
AUDIO UNIT REMOVAL/INSTALLATION
).NOTE: Eject all the discs before removing the audio unit to prevent damaging the CD player's load mechanism.
- Disconnect audio unit connector D (12P) and the HandsFreeLink control unit 28P connector.
- Check for continuity between HandsFreeLink control unit 28P connector terminal No. 24 and body ground.Fig 1: Checking Continuity Between Handsfreelink Control Unit 28P Connector Terminal No. 24 And Body Ground
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Repair a short to body ground in the wire between HandsFreeLink control unit and the audio unit.
NO -Go to step 5.
- Check for continuity between HandsFreeLink control unit 28P connector terminal No. 24 and audio unit connector D (12P) terminal No. 1.Fig 2: Checking Continuity Between Handsfreelink Control Unit 28P Connector Terminal No. 24 And Audio Unit Connector D (12P) Terminal No. 1
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Is there continuity?
YES -Substitute a known-good HandsFreeLink control unit (see CONTROL UNIT INPUT TEST/REPLACEMENT ), and recheck. If the symptom goes away, replace the original HandsFreeLink control unit (see CONTROL UNIT INPUT TEST/REPLACEMENT ). If the symptom does not go away, replace the audio unit (see AUDIO UNIT REMOVAL/INSTALLATION ).
NO -Repair an open in the wire between the HandsFreeLink control unit and the audio unit.