LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio System >> Symptom Troubleshooting >> Audio unit power switch will not turn on (No information display and no sound) (without navigation)

Audio unit power switch will not turn on (No information display and no sound) (without navigation)

NOTE:
  • Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
  • Check the connectors for poor connections or loose terminals.
  1. Turn the ignition switch to ON (II).
  2. Press the power button on to see if the audio unit turns on.

    Does the audio unit display and operate properly, and does the audio unit sound normal? 

    YES  -Intermittent failure, the system is OK at this time.

    NO  -Go to step  3.

  3. Turn the ignition switch to LOCK (0).
  4. Check the No. B1 (15 A) fuse and the No. B14 (7.5 A) fuse in the under-dash fuse/relay box.

    Are the fuses OK? 

    YES  -Go to step  5.

    NO  -Replace the fuse(s), and recheck.

  5. Remove the audio unit (see AUDIO UNIT REMOVAL/INSTALLATION  ). Check that the audio unit is properly connected.
    NOTE: Eject all the discs before removing the audio unit to prevent damaging the CD player's load mechanism.

    Is it connected properly? 

    YES  -Go to step  6.

    NO  -Repair poor connections and reconnect the connector(s), and recheck the function.

  6. Turn the ignition switch to ON (II).
  7. Measure the voltage between body ground and audio unit connector A (24P) terminals No. 3 and No. 24 individually.
    Fig 1: Measuring Voltage Between Body Ground And Audio Unit Connector A (24P) Terminals No. 3 And 24
    G06954254Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there battery voltage on the both terminals? 

    YES  -Go to step  8.

    NO  -Repair an open in the wire(s) between the No. B1 (15 A) fuse and/or the No. B14(7.5 A) fuse in the under-dash fuse/relay box and the audio unit.

  8. Measure the voltage between audio unit connector A (24P) terminal No. 1 and body ground.
    Fig 2: Measuring Voltage Between Audio Unit Connector A (24P) Terminal No. 1 And Body Ground
    G06954255Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there less than 0.2 V? 

    YES  -Substitute a known-good audio unit (see AUDIO UNIT REMOVAL/INSTALLATION  ), and recheck. If the symptom/indication goes away, replace the original audio unit (see AUDIO UNIT REMOVAL/INSTALLATION  ).

    NO  -Repair an open or high resistance in the wire between the audio unit connector A (24P) terminal No. 1 and body ground (G503) (see DASHBOARD WIRE HARNESS (VIEW OF MIDDLE SECTION) (BD) ).