LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio System >> Symptom Troubleshooting >> Audio unit button illumination does not work (without navigation)

Audio unit button illumination does not work (without navigation)

NOTE:
  • Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
  • Check the connectors for poor connections or loose terminals.
  1. Turn the ignition switch to ON (II).
  2. Turn the combination light switch to the parking light position.
  3. Check the illumination of the audio unit buttons.

    Are the buttons illuminated? 

    YES  -Intermittent failure, the audio unit is OK at this time. Check for loose or poor connections at the audio unit connector A (24P).

    NO  -Go to step  4.

  4. Check the illumination of several other buttons not related to the audio system.

    Are the buttons illuminated? 

    YES  -Go to step  5.

    NO  -Troubleshoot the interior lights. Start by checking the No. B29 (10 A) fuse in the under-dash fuse/relay box. If the fuse is OK, check for an open in the wire between the under-dash fuse/relay box and the audio unit.

  5. Turn the ignition switch to LOCK (0).
  6. Remove the audio unit (see AUDIO UNIT REMOVAL/INSTALLATION  ).
    NOTE: Eject all the discs before removing the audio unit to prevent damaging the CD player's load mechanism.
  7. Disconnect audio unit connector A (24P).
  8. Disconnect the gauge control module 32P connector.
  9. Check for continuity between audio unit connector A (24P) terminal No. 2 and gauge control module 32P connector terminal No. 16.
    Fig 1: Checking Continuity Between Audio Unit Connector A (24P) Terminal No. 2 And Gauge Control Module 32P Connector Terminal No. 16
    G06954291Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there continuity? 

    YES  -Go to step  10.

    NO  -Repair an open in the wire between the gauge control module and the audio unit.

  10. Turn the ignition switch to ON (II).
  11. With the combination light switch still on, measure the voltage between audio unit connector A (24P) terminal No. 4 and body ground.
    Fig 2: Measuring Voltage Between Audio Unit Connector A (24P) Terminal No. 4 And Body Ground
    G06954292Courtesy of AMERICAN HONDA MOTOR CO., INC.

    Is there battery voltage? 

    YES  -Check the connections at audio unit connector A (24P). If all connections are OK, replace the audio unit (see AUDIO UNIT REMOVAL/INSTALLATION  ).

    NO  -Repair an open in the wire between the under-dash fuse/relay box and the audio unit.