LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2013 >> CR-Z Base, Automatic CVT Trans >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Turn Signal/Hazard Warning Lights >> Hazard Warning Switch Test/Replacement

Hazard Warning Switch Test/Replacement

  1. Remove the center panel:
  2. Remove the two screws and the hazard warning switch (A).
    NOTE: The illustration shows with audio unit.
    Fig 1: Identifying Hazard Warning Switch Connectors Terminals
    G06954011Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. Check for continuity between the terminals in each switch position according to the table.
    Fig 2: Identifying Hazard Warning Switch Continuity Chart
    G06954012Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. If the continuity is not as specified, remove the cover (A), and replace the switch (B) or bulb (C).
    Fig 3: Removing Cover
    G06954013Courtesy of AMERICAN HONDA MOTOR CO., INC.
  5. Install the switch in the reverse order of removal.
scientia non olet · About LEMON Manuals