VTM-4 LOCK Switch Test/Replacement

Remove the instrument panel (see INSTRUMENT PANEL REMOVAL/INSTALLATION ).
Disconnect the 5P connector (A) from the VTM-4 LOCK switch (B), then remove the VTM-4 LOCK switch.

Fig 1: Identifying 5P Connector And VTM-4 LOCK Switch
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Terminals Switch Position Continuity Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity check is not as specified, replace the bulbs (C) or the VTM-4 LOCK switch.