Rear Door Glass Outer Molding Replacement

Special Tools Required

KTC trim tool set SOJATP2014 *

* Available through the Honda Tool and Equipment Program; call 888-424-6857

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the door or the related parts.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

Lower the glass fully.
Starting at the front, pull up the door glass outer molding (A) to release the clips (B).

Fig 1: Pulling Up Door Glass Outer Molding
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Release from the front portion of the glass outer molding (A) from the glass run channel (B).

Fig 2: Releasing Front Portion Of Glass Outer Molding From Glass Run Channel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the glass outer molding in the reverse order of removal, and note these items:
- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure the front portion of the glass outer weatherstrip catches the glass run channel properly.