Select/Reset Switch Test/Replacement

Remove the instrument panel (see INSTRUMENT PANEL REMOVAL/INSTALLATION ).
Carefully push out the select/reset switch (A) from behind the instrument panel, and disconnect the connector from it.

Fig 1: Identifying Select/Reset Switch And Instrument Panel
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Check for continuity between the terminals in each switch position according to the table.

Fig 2: Terminal Continuity Reference Chart
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If the continuity is not as specified, replace the illumination bulb (B) or the switch.
Install the switch in the reverse order of removal.