DTC B1152: Gauge Control Module Internal Error (EEPROM) Error
NOTE:
If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A (see TROUBLESHOOTING - B-CAN SYSTEM DIAGNOSIS TEST MODE A
).
- Clear the DTCs with the HDS.
- Turn the ignition switch to LOCK (0) and then back to ON (II).
- Check for DTCs with the HDS.
Is DTC B1152 indicated?
YES -Replace the gauge control module (see Gauge Control Module Replacement ■
NO -Intermittent failure. The system is OK at this time. Check for loose or poor connections. ■