Entering the Self-Diagnostic Function
Before doing the self-diagnostic function, make sure the No. 7 (7.5 A) fuse, the No. 21 (7.5 A) fuse and the No. 32 (7.5 A) in the under-dash fuse/relay box.
- Push and hold the RESET switch button.
- Turn the lighting switch ON.
- Turn the ignition switch to ON (II).
- Within 5 sec, turn the lighting switch OFF, then ON and OFF again.
- Within 5 sec, release the RESET switch button, and then push and release the button three times repeatedly.
NOTE:
- While in the self-diagnostic mode, the dash lights brightness controller operates normally.
- While in the self-diagnostic mode, the RESET button is used to start the Beeper Drive Circuit Test and the Gauge Drive Circuit Check.
- If the vehicle speed exceeds 1.2 mph (2 km/h) or the ignition switch is turned to LOCK (0), the self-diagnostic mode ends.