Rocker Arm Assembly Removal

Rocker Arm Assembly Removal

Front

1. Remove the cylinder head cover.

2. Loosen the locknuts and the adjusting screws (A).






3. Remove the rocker shaft bridge mounting bolts, the front rocker arm oil control valve mounting bolts, and the rocker arm assembly.

1. Loosen the rocker shaft bridge mounting bolts and the front rocker arm oil control valve mounting bolts in sequence two turns at a time, to prevent damaging the valves or the rocker arm assembly.

2. When removing the rocker arm assembly, do not remove the rocker shaft bridge mounting bolts and the rocker shaft holder mounting bolts. The bolts will keep the rocker arms on the shafts.






Rear

1. Remove the cylinder head cover.

2. Loosen the locknuts and the adjusting screws (A).






3. Remove the rocker shaft bridge mounting bolts, the rear rocker arm oil control valve mounting bolts, and the rocker arm assembly.

1. Loosen the rocker shaft bridge mounting bolts and the rear rocker arm oil control valve mounting bolts in sequence two turns at a time, to prevent damaging the valves or the rocker arm assembly.

2. When removing the rocker arm assembly, do not remove the rocker shaft bridge mounting bolts and the rocker shaft holder mounting bolts. The bolts will keep the rocker arms on the shafts.