Selector Control Shaft Oil Seal Replacement

Special Tools Required 

• Attachment, 22 x 24 mm 07746-001A800
• Driver Handle, 15 x 135L 07749-0010000

1. Remove the oil seal from the transmission housing.
   Fig 1: Identifying Transmission Housing Oil Seal

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new oil seal (A) in the transmission housing to a depth (B) of 0.3-1.0 mm (0.012-0.039 in) below the transmission housing surface (C) using the 15 x 135L driver handle and the 22 x 24 mm attachment.
   Fig 2: Installing Oil Seal In Transmission Housing To Depth Of 0.3-1.0 mm (0.012-0.039 in) Below Transmission Housing Surface

   Courtesy of AMERICAN HONDA MOTOR CO., INC.