Selector Control Shaft Bearing Replacement

Special Tools Required 

• Driver Handle, 15 x 135L 07749-0010000
• Bearing Remover Shaft Set, 15 mm 07936-KC10500
• Slide Hammer 07936-371020A
• Bearing Driver Attachment, 28 x 30 mm 07946-1870100

1. Remove the selector control shaft bearing from the transmission housing using the 15 mm bearing remover shaft and the slide hammer.
   Fig 1: Removing Selector Control Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing until it bottoms in the transmission housing using the 15 x 135L driver handle and the 28 x 30 mm bearing driver attachment.
   Fig 2: Installing Bearing Until It Bottoms In Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.