Idler Gear Shaft Bearing Replacement

Special Tools Required 

• Bearing Driver Attachment, 37x40 mm 07746-0010200
• Driver Handle, 15 x 135L 07749-0010000
• Slide Hammer 07936-371020A
• Remover Handle 07936-3710100
• Bearing Remover Shaft Set, 22 mm 070MC-MFR0100

1. Heating the transmission housing to about 212°F (100°C) using a heat gun (A). Do not heat the transmission housing more than 212°F (100°C).
   Fig 1: Heating Transmission Housing To About 212°F (100°C) Using Heat Gun

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Remove the idler gear shaft bearing from the transmission housing using the 22 mm bearing remover shaft, the remover handle, and the slide hammer.
   Fig 2: Removing Idler Gear Shaft Bearing From Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. Install a new bearing until it bottoms in the transmission housing using the 15 x 135L driver handle and the 37 x 40 mm bearing driver attachment.
   Fig 3: Installing Bearing Until It Bottoms In Transmission Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.