Transmission Fluid Pressure Switch A (2nd Clutch) Replacement

WARNING: This page is about a different variant/trim than selected.

Raise the vehicle on a lift, or apply the parking brake, block both rear wheels, and raise the front of the vehicle. Make sure it is securely supported.
Disconnect the transmission fluid pressure switch A (2nd clutch) connector, and remove transmission fluid pressure switch A (2nd clutch) (A) and the sealing washer (B).

Fig 1: Locating Transmission Fluid Pressure Switch A (2nd Clutch) And Sealing Washer With Torque Specifications
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install a new transmission fluid pressure switch A (2nd clutch) with a new sealing washer, and tighten the switch.
Check the connector for corrosion, dirt, or oil, and clean or repair if necessary, then connect the connector securely.