LEMON Manuals: Even more car manuals for everyone
Home >> Honda >> 2012 >> Odyssey LX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission - 6-Speed) >> Shafts and Clutches >> 1st Gear One-Way Clutch Inspection

1st Gear One-Way Clutch Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Install the 53 x 57 x 20 mm needle bearing (A) and 1st gear (B) on the park gear (C).
    Fig 1: Locating 53 x 57 x 20 mm Needle Bearing, 1st Gear And Park Gear
    G06969388Courtesy of AMERICAN HONDA MOTOR CO., INC.
  2. Hold the park gear (A), and turn 1st gear (B) in the direction shown to be sure it turns freely. Also make sure 1st gear locks in the opposite direction.
    Fig 2: Locating Park Gear And 1st Gear
    G06969389Courtesy of AMERICAN HONDA MOTOR CO., INC.
  3. If any problem occurs on the 1st gear one-way clutch, replace 1st gear. The 1st gear one-way clutch is not available separately from 1st gear.
scientia non olet · About LEMON Manuals