How to End a Troubleshooting Session (required after any troubleshooting)
WARNING: This page is about a different variant/trim than selected.
NOTE:
Reset the PCM/TCM with the HDS while the engine is stopped.
- Turn the ignition switch to LOCK (0).
- Turn the ignition switch to ON (II), and wait for 30 seconds, then disconnect the HDS from the DLC.
- Start the engine with the shift lever in P or N, and warm it up to normal operating temperature (the radiator fan comes on).
- To verify that the problem is repaired, test-drive the vehicle for several minutes at speeds over 31 mph (50 km/h) or under the same conditions as those indicated by the freeze data.