Rewriting the ODO Data on a New Gauge Control Module: Notes

NOTE:

Obtain a new gauge control module before starting the rewriting process. Only new gauges can be rewritten.
Rewriting is not possible on a gauge control module that will not communicate with the HDS.
Make sure that the HDS shows the correct VIN for the vehicle you are working on.
Once you have started this procedure, you must complete it before removing the HDS from the Data Link Connector (DLC).
Connect a jumper battery (do not connect a battery charger) to insure that correct battery voltage is maintained.
Check any official Honda service website for more service information about the odometer.