Passenger's Air Mix Control Motor Test

Special Tools Required 

Backprobe Set 07SAZ-001000A

1. Disconnect the 7P connector from the passenger's air mix control motor.
   NOTE: Incorrectly applying power and ground to the passenger's air mix control motor will damage it. Follow the instructions carefully.
2. Connect battery power to terminal No. 6 of the passenger's air mix control motor, and ground terminal No. 7; the passenger's air mix control motor should run, and stop at Max Cool. If it does not, reverse the connections; the passenger's air mix control motor should run, and stop at Max Hot. When the passenger's air mix control motor stops running, disconnect battery power immediately.
   Fig 1: Identifying Passenger's Air Mix Control Motor Terminals

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. If the passenger's air mix control motor did not run in step  2, remove it, then check the passenger's air mix control linkage and door for smooth movement.
   • If the linkage and door move smoothly, replace the passenger's air mix control motor (see PASSENGER'S AIR MIX CONTROL MOTOR REPLACEMENT  ).
   • If the linkage or door sticks or binds, repair them as needed.
   • If the passenger's air mix control motor runs smoothly, go to step 4.
4. Measure the resistance between terminals No. 1 and No. 3. It should be between 4.2 to 7.8 kΩ.
5. Reconnect the passenger's air mix control motor 7P connector, then turn the ignition switch to ON (II).
6. Using the backprobe set, measure the voltage between terminals No. 1 and No. 5.

   Max Cool: about 1.0 V 

   Max Hot: about 4.0 V 

7. If either the resistance or voltage readings are not as specified, replace the passenger's air mix control motor (see PASSENGER'S AIR MIX CONTROL MOTOR REPLACEMENT  ).