Coin Pocket Removal/Installation

NOTE: Take care not to scratch the dashboard or the related parts.

From under the dash, remove the screws, then remove the coin pocket (A).

Fig 1: Identifying Coin Pocket With Mounting Screws
Courtesy of AMERICAN HONDA MOTOR CO., INC.
If necessary, release the pocket spring (A) from the pocket panel (B) and the pocket (C). Release the projections (D), then remove the pocket from the pocket panel.

Fig 2: Identifying Pocket Spring, Pocket Panel, Pocket, Projections And Pocket Hooks
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install the pocket in the reverse order of removal, and note these items:
- Be sure the pocket spring ends are installed in the holes (E) of the pocket panel.
- Be sure to install the pocket spring on the pocket hooks (F).