Disconnecting the motor power cable connector from the motor stator
Turn the ignition switch to LOCK (0). Turn the battery module switch OFF.
Slide the protector (A) in the direction of the arrow. Push the tab (B), then raise the lever (C). Remove the IMA motor power cable (D) from the motor stator.
NOTE:
- If the outside of the IMA motor power cable connector is dirty, clean it before you disconnect it.
- Cover the disconnected connector (E) with a plastic bag (F), and wrap the IMA motor power cable terminals with insulating tape (G).
- If the IMA motor power cable is wet, dry them with a clean shop towel. Do not use compressed air.