A/T Secondary Shaft 1st Clutch Hub Replacement

A/T Secondary Shaft 1st Clutch Hub Replacement

Special Tools Required

- Driver Handle, 15 x 135L 07749-0010000
- Driver Attachment, 43.5 mm 07947-6340500
- Attachment, 78 x 90 mm 07GAD-SD40101

1. Remove the 1st-hold clutch hub (A) from 1st gear (B) using the driver handle (15 x 135L), the driver attachment (43.5 mm), and a press.





2. Remove the 1st clutch hub (C) from 1st gear.

3. Install a new 1st clutch hub (A) over 1st gear (B), and install the 1st-hold clutch hub (C) in 1st gear.






4. Install the 1st-hold clutch hub (A) in 1st gear (B) using the driver handle (15 x 135L), the attachment (78 x 90 mm), and the press.