Immobilizer Indicator Does Not Go Off

Immobilizer System Symptom Troubleshooting - Immobilizer indicator does not go off

Immobilizer indicator does not go off

1. Turn the ignition switch to LOCK (0).

2. Connect the HDS to the data link connector.

3. Turn the ignition switch to ON (II).

4. From the SYSTEM SELECTION MENU, enter IMMOBI, then select IMMOBILIZER SETUP, then select SYSTEM CHECK, Number of Keys, and Status Log.

5. Do the SYSTEM CHECK with the HDS.

Is N-1 OK indicated?

YES -

Do the gauge control module self-diagnostic function test Initial Inspection and Diagnostic Overview. If the gauge control module is faulty, replace it.�

NO -

Substitute a known-good immobilizer-keyless control unit, then register it and recheck. If the symptom goes away, replace the original immobilizer-keyless control unit Service and Repair.�